Engineering topics

Benford, Dominic J.

Publications and source records attributed to Benford, Dominic J..

61 records · Page 4

NASA NTRS2003

The Single Aperture Far-Infrared (SAFIR) Observatory and its Cryogenic Detector Needs

The development of a large, far-infrared telescope in space has taken on a new urgency with breakthroughs in detector technology and recognition of the fundamental importance of the far-infrared spectral region to questions ranging from cosmology to our own Solar System. The Single Aperture Far-InfraRed (SAFIR) Observatory is l0m-class far-infrared observatory that would begin development later in this decade to meet these needs. SAFIR's science goals are driven by the fact that youngest stages of almost all phenomena in the universe are shrouded in absorption by and emission from cool dust that emits strongly in the far-infrared, 20 microns - 1mm. Its operating temperature (4 K) and instrument complement would be optimized to reach the natural sky confusion limit in the far-infrared with diffraction-limited performance down to at least the atmospheric cutoff at 40 microns. This would provide a point source sensitivity improvement of several orders of magnitude over that of SIRTF. In order to achieve this, large arrays of detectors with NEPs ranging from a few to a hundred zeptowatts/sqrt(Hz) are needed. Very low temperature superconducting transition edge sensors and far-infrared "photon counting" detectors are critical technologies requiring development for the SAFIR mission.

Benford, Dominic J.↗

NASA NTRS2003

Optical Properties of Zitex in the Infrared Submillimeter

The results of measurements of the refractive index and power attenuation coefficient of Zitex at 290K, 77K, and 4K in the spectral region from 1 to 1000 microns are presented. Zitex is a porous Teflon sheet with a filling factor of approx. 50%, and is manufactured in several varieties as a filter paper. Zitex is found to be an effective IR block, with thin (200 microns) sheets transmitting less than 1% in the 1 - 50 microns range while attenuating less than or approx. 10% at wavelengths longer than 200 microns. Some variation in the cutoff wavelength is seen, tending to be a shorter wavelength cutoff for a smaller pore size. Additionally, the thermal conductivity of Zitex at cryogenic temperatures has been measured, and is found to be roughly one-half that of bulk Teflon. Finally, its dielectric constant has been measured in the submillimeter as n = 1.20, resulting in extremely low dielectric reflection losses. As a result, Zitex is particularly useful as an IR blocking filter in low-noise heterodyne receivers; in the millimeter-wave range (lambda greater than approx. 850 microns or nu less than or = 350 GHz) the attenuation of alpha less than or = 0.01/cm for a 3.5 mm thickness filter of Zitex G125 would raise receiver noise temperatures by less than 1K.

Benford, Dominic J.↗

NASA NTRS2002

Probing Galaxy Formation and Submillimeter Surveys

Multiwavelength observations of galaxies have revealed that a significant fraction of the their stellar or accretion luminosity is absorbed and reradiated by dust at far-infrared (FIR) and submillimeter (submm) wavelengths. Submillimeter (850 micron) surveys conducted by the SCUBA instrument on the JCMT have detected a population of high redshift (z approximately equal to 1-4) ultraluminous infrared galaxies, that dominate the luminosity densities at those redshifts. Their cumulative contribution to the cosmic infrared background (CIB) detected by the COBE satellite is comparable to the observations, suggesting that at 850 microns the CIB is resolved into its constituent sources. This suggests that the early universe was much more dust enshrouded than the present one. FIR and submm surveys can therefore address fundamental questions regarding the early processes of galaxy formation and their evolution in number and luminosity over cosmic history. The scientific information that can be obtained from such surveys depend on a number of parameters, the most important of which are the diameter of the telescope and the wavelengths of the survey. We summarize the effect of these parameters on the scientific return from such surveys.

Dwek, Eli↗

NASA NTRS2002

Design and Fabrication of Two-Dimensional Semiconducting Bolometer Arrays for the High Resolution Airborne Wideband Camera (HAWC) and the Submillimeter High Angular Resolution Camera II (SHARC-II)

The High resolution Airborne Wideband Camera (HAWC) and the Submillimeter High Angular Resolution Camera II (SHARC 11) will use almost identical versions of an ion-implanted silicon bolometer array developed at the National Aeronautics and Space Administration's Goddard Space Flight Center (GSFC). The GSFC "Pop-Up" Detectors (PUD's) use a unique folding technique to enable a 12 x 32-element close-packed array of bolometers with a filling factor greater than 95 percent. A kinematic Kevlar(Registered Trademark) suspension system isolates the 200 mK bolometers from the helium bath temperature, and GSFC - developed silicon bridge chips make electrical connection to the bolometers, while maintaining thermal isolation. The JFET preamps operate at 120 K. Providing good thermal heat sinking for these, and keeping their conduction and radiation from reaching the nearby bolometers, is one of the principal design challenges encountered. Another interesting challenge is the preparation of the silicon bolometers. They are manufactured in 32-element, planar rows using Micro Electro Mechanical Systems (MEMS) semiconductor etching techniques, and then cut and folded onto a ceramic bar. Optical alignment using specialized jigs ensures their uniformity and correct placement. The rows are then stacked to create the 12 x 32-element array. Engineering results from the first light run of SHARC II at the CalTech Submillimeter Observatory (CSO) are presented.

Voellmer, George M.↗

NASA NTRS2002

Design and Fabrication of Two-Dimensional Semiconducting Bolometer Arrays for the High Resolution Airborne Wideband Camera (HAWC) and the Submillimeter High Angular Resolution Camera II (SHARC-II)

The High resolution Airborne Wideband Camera (HAWC) and the Submillimeter High Angular Resolution Camera II (SHARC II) will use almost identical versions of an ion-implanted silicon bolometer array developed at the National Aeronautics and Space Administration's Goddard Space Flight Center (GSFC). The GSFC 'Pop-up' Detectors (PUD's) use a unique folding technique to enable a 12 x 32-element close-packed array of bolometers with a filling factor greater than 95 percent. A kinematic Kevlar(trademark) suspension system isolates the 200 mK bolometers from the helium bath temperature, and GSFC - developed silicon bridge chips make electrical connection to the bolometers, while maintaining thermal isolation. The JFET preamps operate at 120 K. Providing good thermal heat sinking for these, and keeping their conduction and radiation from reaching the nearby bolometers, is one of the principal design challenges encountered. Another interesting challenge is the preparation of the silicon bolometers. They are manufactured in 32-element, planar rows using Micro Electro Mechanical Systems (MEMS) semiconductor etching techniques, and then cut and folded onto a ceramic bar. Optical alignment using specialized jigs ensures their uniformity and correct placement. The rows are then stacked to create the 12 x 32-element array. Engineering results from the first light run of SHARC II at the Caltech Submillimeter Observatory (CSO) are presented.

Voellmer, George M.↗

NASA NTRS2001

Multiplexed Readout of Thermal Bolometers with Superconducting Transition Edge Thermometers

History shows that in astronomy, more is better. In the near future, direct detector arrays for the far-infrared and submillimeter will contain hundreds to thousands of elements. A multiplexed readout is necessary for practical implementation of such arrays, and has been developed using SQUIDs. The technology permits a 32 x 32 array of bolometers to be read out using approximately 100 wires rather than the >2000 needed with direct wiring. These bolometer arrays are made by micromachining techniques, using superconducting transition edge sensors as the thermistors. We describe the development of this multiplexed superconducting bolometer array architecture as a step toward bringing about the first astronomically useful arrays of this design. This technology will be used in the Submillimeter and Far Infrared Experiment (SAFIRE) instrument on Stratospheric Observatory for Infrared Astronomy (SOFIA), and is a candidate for a wide variety of other spectroscopic and photometric instruments.

Benford, Dominic J.↗

NASA NTRS2001

Ecological Niches for Space Missions in the Far-Infrared

The far-infrared and submillimeter region (30 micrometers-750 micrometers) has perhaps the greatest potential of all wavelengths for advancement in astronomy. When viewed in terms of the cosmic backgrounds, the fares is extremely important: half of the total luminosity in the Universe is emitted at rest wavelengths approximately 80 - 100 micrometers. At the highest known galaxy redshifts (z approximately equal to 6) this energy is redshifted to approximately 600 micrometers. Existing and planned survey missions have a broad range of capabilities, defined in terms of their spectral coverage, spectral resolution, survey area, and sensitivity. In this 4-dimensional parameter space, the flares is found to be substantially behind most other wavelength bands. The opportunity for future missions with great discovery potential is evident. Such missions will be wellsuited to answering fundamental questions about the history of energy release in the Universe, the formation and evolution of galaxies, and formation of stellar and protoplanetary systems. We discuss the parameter space that can be filled by a few well-chosen space missions, specifically a submillimeter all-sky survey and a far-IR to submillimeter observatory.

Benford, Dominic J.↗