Engineering Papers⌕ Search

Engineering topics

Bedick, Clinton

Publications and source records attributed to Bedick, Clinton.

29 records · Page 2
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

A Modeling Study on Ammonia and Ammonia/Hydrogen Kinetics for Gas Turbine Engines

The use of ammonia as a fuel source in gas turbine engine power cycles represents an attractive means to decarbonize the energy sector due to higher energy density and achieving liquid state at far lower pressures compared to pure hydrogen. However, due to low flammability and a propensity for high NOx emissions, its use is not without challenge. Here, a number of 0D and 1D modeling tools were utilized to study the combustion characteristics of ammonia and ammonia/hydrogen mixtures, examining basic fundamental properties such as laminar flame speed, variability among existing chemical kinetic mechanisms, and considering the use of two-stage rich-lean combustion strategies to achieve low NOx emissions.

42 ENGINEERING↗
DOE OSTI2021

Parametric Evaluation of RDE Inlet Performance using a Reduced-Order Model

This paper presents the results of a parametric study on the effects of inlet restriction, along with a number of other controlling parameters, using a previously developed reduced-order RDE inlet model. The results of this study will be used to inform subsequent high-fidelity CFD simulations and/or selection of experimental operating conditions which may be conducive to maximizing performance.

Bedick, Clinton↗
DOE OSTI2021

Computational Fluid Dynamics Combustion Modeling for Rotating Detonation Engines

This paper focuses on the development and validation of a combustion model for Computational Fluid Dynamics (CFD) modeling of Rotating Detonation Engines. A zero-dimensional Partially Stirred Reactor (PaSR) with a detailed chemical kinetic mechanism for hydrogen and air is used to model turbulent combustion. The model is computationally efficient and is based on the notion of partial mixing at the sub-grid level with turbulent exchange between mixed and unmixed regions. The ability of the PaSR model to accurately represent both detonative and deflagrative combustion is assessed by validating the results against experimental data. The effects of mesh resolution on the solution are also studied in order to determine if a mesh independent solution is obtainable with the Large Eddy Simulation (LES) approach to modeling turbulence. A comparison is made between the PaSR model and simply ignoring turbulence chemistry interactions which assumes that all species are perfectly mixed at the sub-grid level.

Strakey, Peter↗
DOE OSTI2020

Prototyping of N95 Respirators Using Additive Manufacturing NETL NLVB (Final Report)

Final report for National Energy Technology Laboratory (NETL) project involving the use of advanced manufacturing and 3D printing technologies to help address personal protective equipment (PPE) shortages due to COVID-19. Work was performed in support of Joint DOE Laboratory Plan for Manufacturing Medical Supplies and funded through the DOE Office of Science.

3D Printing↗