Engineering Papers⌕ Search

Engineering topics

Beckstead, M. W.

Publications and source records attributed to Beckstead, M. W..

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

An Overview of Combustion Mechanisms and Flame Structures for Advanced Solid Propellants

Ammonium perchlorate (AP) and cyclotretamethylenetetranitramine (HMX) are two solid ingredients often used in modern solid propellants. Although these two ingredients have very similar burning rates as monopropellants, they lead to significantly different characteristics when combined with binders to form propellants. Part of the purpose of this paper is to relate the observed combustion characteristics to the postulated flame structures and mechanisms for AP and HMX propellants that apparently lead to these similarities and differences. For AP composite, the primary diffusion flame is more energetic than the monopropellant flame, leading to an increase in burning rate over the monopropellant rate. In contrast the HMX primary diffusion flame is less energetic than the HMX monopropellant flame and ultimately leads to a propellant rate significantly less than the monopropellant rate in composite propellants. During the past decade the search for more energetic propellants and more environmentally acceptable propellants is leading to the development of propellants based on ingredients other than AP and HMX. The objective of this paper is to utilize the more familiar combustion characteristics of AP and HMX containing propellants to project the combustion characteristics of propellants made up of more advanced ingredients. The principal conclusion reached is that most advanced ingredients appear to burn by combustion mechanisms similar to HMX containing propellants rather than AP propellants.

Beckstead, M. W.↗
NASA NTRS2000

Examples of Unsteady Combustion in Non-Metallized Propellants

For over thirty years the T-Burner has been the de facto standard for determining the unstable response of solid propellants. This paper reviews some of the different approaches that have been used, and briefly summarizes advantages and disadvantages of the different techniques. Data from a variety of sources have been reviewed and summarized showing the effect of various test conditions and propellant formulation variations. Much of the data taken in the 60's and early 70's were with so-called research propellants, with relatively low solids loading and usually monomodal AP as the oxidizer. Later data were obtained with propellants containing solids loading more typical and practical propellants. Several distinct differences were observed in the data for the different types of propellants. Data varying AP particle size distributions indicate that either additional fine AP or finer AP usually increases the propellant response. A significant reduction in the response can be achieved by reducing the amount of fine AP, while holding burning rate constant either by adding a catalyst or by varying the overall AP size distribution. A significant amount of data has been obtained for reduced smoke propellants containing stability additives. The data indicate that the additives provide significant particle damping, and most often, also reduce the propellant response. Data from double base propellants indicate a much broader response over a wide frequency range. This implies that double base propellants should be more unstable in tangential modes than composite propellants. This trend seems to be consistent with observed motor data. Measuring the response of metallized propellants has been a challenge due to the large damping due to metal oxide particles in the gas. Data from metallized propellants are not presented here, but will be summarized in a future paper.

Beckstead, M. W.↗
NASA NTRS1980

Workshop report: Velocity coupling

Velocity coupled combustion instability and related combustion instability topics were considered. The knowledge of velocity coupled combustion instability was assessed; the state of the art of velocity coupled measurement techniques was determined; and particularly laboratory devices or T burner related devices; recommendations were made on how to improve the state of knowledge on velocity coupled combustion instability. Test conditions for a round robin of velocity coupled response measurement techniques were established.

Beckstead, M. W.↗