Ballard, G. K. | Engineering Papers

NASA NTRS1985

Fabricating Thin-Shell Heat-Transfer Models

Freestanding shells produced for experimental aerodynamic-heating tests. Heat transfer shells require several steps and several precise molds. First, interlocking aluminum male and female molds fabricated. Holes for thermocouples drilled through male mold at desired locations. Wires having same diameter as thermocouple wire placed through holes in male mold flush to female mold. Epoxy exposed to vacuum to remove air bubbles poured between male and female molds to form thin female mold. Once mold cured, wires removed and aluminum molds separated.

Avery, D. E.↗

NASA NTRS1984

Electroless-plating technique for fabricating thin-wall convective heat-transfer models

A technique for fabricating uniform thin-wall metallic heat-transfer models and which simulates a Shuttle thermal protection system tile is described. Two 6- by 6- by 2.5-in. tiles were fabricated to obtain local heat transfer rates. The fabrication process is not limited to any particular geometry and results in a seamless thin-wall heat-transfer model which uses a one-wire thermocouple to obtain local cold-wall heat-transfer rates. The tile is relatively fragile because of the brittle nature of the material and the structural weakness of the flat-sided configuration; however, a method was developed and used for repairing a cracked tile.

Avery, D. E.↗