Engineering Papers⌕ Search

Engineering topics

Baker, L. R., Jr.

Publications and source records attributed to Baker, L. R., Jr..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Input guide for computer programs to generate thermodynamic data for air and Freon CF4

FORTRAN computer programs were developed to calculate the thermodynamic properties of Freon 14 and air for isentropic expansion from given plenum conditions. Thermodynamic properties for air are calculated with equations derived from the Beattie-Bridgeman nonstandard equation of state and, for Freon 14, with equations derived from the Redlich-Quang nonstandard equation of state. These two gases are used in scale model testing of model rocket nozzle flow fields which requires simulation of the prototype plume shape with a cold flow test approach. Utility of the computer programs for use in analytical prediction of flow fields is enhanced by arranging card or tape output of the data in a format compatible with a method-of-characteristics computer program.

Tevepaugh, J. A.↗
NASA NTRS1973

Analysis of SRM model nozzle calibration test data in support of IA12B, IA12C and IA36 space shuttle launch vehicle aerodynamics tests

Variations of nozzle performance characteristics of the model nozzles used in the Space Shuttle IA12B, IA12C, IA36 power-on launch vehicle test series are shown by comparison between experimental and analytical data. The experimental data are nozzle wall pressure distributions and schlieren photographs of the exhaust plume shapes. The exhaust plume shapes were simulated experimentally with cold flow while the analytical data were generated using a method-of-characteristics solution. Exhaust plume boundaries, boundary shockwave locations and nozzle wall pressure measurements calculated analytically agree favorably with the experimental data from the IA12C and IA36 test series. For the IA12B test series condensation was suspected in the exhaust plumes at the higher pressure ratios required to simulate the prototype plume shapes. Nozzle calibration tests for the series were conducted at pressure ratios where condensation either did not occur or if present did not produce a noticeable effect on the plume shapes. However, at the pressure ratios required in the power-on launch vehicle tests condensation probably occurs and could significantly affect the exhaust plume shapes.

Baker, L. R., Jr.↗
NASA NTRS1972

Abort separation of the shuttle

A sensitivity analysis of the factors which affect a successful abort maneuver following a space shuttle launching is presented. Wind tunnel tests were conducted using optimum simulation techniques and data acquisition procedures. Static stability, dynamic stability, and local loads were investigated. It is concluded that parallel abort separation of the space shuttle components is possible at both high and low dynamic pressures. Successful separation is dependent upon configuration, Mach number, rocket exhaust impingement and relative position and attitude of the stages.

Decker, J. P.↗
NASA NTRS1971

Calibration of propulsion simulation nozzles for space shuttle booster and orbiter models for the abort/separation staging experimental program

An experimental program to determine the power-on aerodynamic flight characteristics of the booster and orbiter vehicles during the abort separation maneuver is reported. An essential contribution to such a test program is the gas dynamic simulation of the size and shape of the plumes emitting from the full-scale orbiter and booster main propulsion systems. The two major effects of the plume which must be simulated are: the interaction of the plume with the external flow field, and the direct impingement of the plumes on surfaces which are enveloped by the plume. To accomplish the objective of correct plume simulation, the similarity parameters developed by Herron and the requirement to match momentum flux per unit area between the model and the full-scale systems, were applied to the orbiter and booster propulsion systems.

Baker, L. R., Jr.↗