Engineering topics

Bachalo, W. D.

Publications and source records attributed to Bachalo, W. D..

45 records · Page 3

NASA NTRS1979

Transonic flow past a symmetrical airfoil at high angle of attack

The results of an experimental investigation of shock-induced stall and leading-edge stall on a 64A010 airfoil section are presented. Advanced nonintrusive techniques - laser velocimetry, holographic interferometry, and buried-wire anemometry - were used in characterizing the inviscid and viscous flow regions. The measurements include Mach contours of the inviscid flow regions, and mean velocity, flow direction and Reynolds shear stress profiles in the separated regions. The experimental observations of this study are relevant to efforts to improve surface pressure prediction methods for airfoils at or near stall.

Johnson, D. A.↗

NASA NTRS1979

Laser velocimetry and holographic interferometry measurements in transonic flows

Measurements of the transonic flow about a two-dimensional airfoil have been made with holographic interferometry and laser velocimetry. Quantitative data obtained with the interferometer are compared to the laser velocimeter and surface pressure measurements to evaluate the accuracy of the technique. Good agreement in the results confirmed the two-dimensionality of the flow and the potential of the interferometer in making unsteady transonic flow measurements in the future.

Bachalo, W. D.↗

NASA NTRS1978

Transonic flow about a two-dimensional airfoil inviscid and turbulent flow properties.

Flow-field measurements are presented for a symmetrical NACA 64A010 airfoil section at transonic conditions. Measurements were obtained for three angles of attack with the free-stream Mach number fixed at 0.8. The cases studied included a weak shock wave/boundary layer interaction, an interaction of medium strength with mild separation, and an interaction of sufficient strength to produce a shock-induced stall situation. Two nonintrusive optical techniques, laser velocimetry and holographic interferometry, were used to characterize the flows. The results include Mach number contours and flow angle distributions in the inviscid flow regions, and turbulent flow properties, including the turbulent Reynolds stresses, of the upper surface viscous layers, and of the near-wake. The turbulent flow measurements reveal that the turbulence fluctuations attain equilibrium with the local mean flow much faster than previously expected.

Johnson, D. A.↗

NASA NTRS1978

Holography and LDV techniques, their status and use in airfoil research

The measurement capabilities of laser velocimetry and holographic interferometry in transonic airfoil testing were demonstrated. Presented are representative results obtained with these two nonintrusive techniques on a 15.24 cm chord airfoil section. These results include the density field about the airfoil, flow angles in the inviscid flow and viscous flow properties including the turbulent Reynolds stresses. The accuracies of the density fields obtained by interferometry were verified from comparisons with surface pressure and laser velocimeter measurements.

Johnson, D. A.↗

NASA NTRS1977

Experiments on transonic and supersonic turbulent boundary-layer separation

Results of experimental investigations into turbulent boundary-layer behavior under the influence of pressure gradients and with separation are presented for transonic and supersonic flow fields. In the transonic case, an axisymmetric model was implemented consisting of an annular circular arc bump affixed to a circular cylinder aligned with the flow direction. For the supersonic separation study, an oblique shock wave impinging on the wind tunnel wall boundary layer was employed to cause separation. The mean streamwise and normal velocity components as well as the respective turbulence intensities were obtained with a two-color frequency shifted laser velocimeter.

Bachalo, W. D.↗

NASA NTRS1976

Laser velocimetry applied to transonic and supersonic aerodynamics

As a further demonstration of the capabilities of laser velocity in compressible aerodynamics, measurements obtained in a Mach 2.9 separated turbulent boundary layer and in the transonic flow past a two-dimensional airfoil section are presented and compared to data realized by conventional techniques. In the separated-flow study, the comparisons were made against pitot-static pressure data. Agreement in mean velocities was realized where the pressure measurements could be considered reliable; however, in regions of instantaneous reverse velocities, the laser results were found to be consistent with the physics of the flow whereas the pressure data were not. The laser data obtained in regions of extremely high turbulence suggest that velocity biasing does not occur if the particle occurrence rate is low relative to the turbulent fluctuation rate. Streamwise turbulence intensities are also presented. In the transonic airfoil study, velocity measurements obtained immediately outside the upper surface boundary layer of a 6-inch chord MACA 64A010 airfoil are compared to edge velocities inferred from surface pressure measurements. For free-stream Mach numbers of 0.6 and 0.8, the agreement in results was very good. Dual scatter optical arrangements in conjunction with a single particle, counter-type signal processor were employed in these investigations. Half-micron-diameter polystyrene spheres and naturally occurring condensed oil vapor acted as light scatterers in the two respective flows. Bragg-cell frequency shifting was utilized in the separated flow study.

Johnson, D. A.↗

NASA NTRS1976

Laser velocimetry applied to transonic and supersonic aerodynamics

Measurements obtained with laser velocimetry in a Mach 2.9 separated turbulent boundary layer and in the transonic flow past a two-dimensional airfoil section are presented and compared to data realized by conventional techniques. Agreement in mean velocities was realized where the pressure measurements could be considered reliable; however, in regions of instantaneous reverse velocities, the laser results were found to be consistent with the physics of the flow whereas the pressure data were not. Streamwise turbulence intensities are also presented. In the transonic airfoil study, velocity measurements obtained immediately outside the upper surface boundary layer of a 6-inch chord NACA 64A010 airfoil are compared to edge velocities inferred from surface pressure measurements. For free-stream Mach numbers of 0.6 and 0.8, the agreement in results was very good. "Dual scatter" optical arrangements in conjunction with a single particle, counter-type signal processor were employed in these investigations.

Johnson, D. A.↗

NASA NTRS1976

Laser velocimeter supersonic and transonic wind tunnel studies

Wind tunnel investigations of a shock-induced separated flow and the flow about a two-dimensional airfoil section at transonic speeds using laser velocimetry techniques are described. Laser velocimeter data are presented and compared with conventional pressure type measurements (pitot and static pressure probe measurements for the shock-induced separation, and surface pressure measurements for the two-dimensional airfoil section). In addition to these data comparisons, a simple optical arrangement for the incorporation of a Bragg cell in a laser velocimeter system is described. The effects of particle concentration gradients within a turbulent boundary layer on laser velocimeter measurements are also demonstrated.

Johnson, D. A.↗

NASA NTRS1975

Experiments on supersonic boundary-layer separation in three dimensions

A detailed experimental study of three-dimensional separation in supersonic flow is described. Three-dimensional wedges affixed to flat plates were used to generate the flow fields that were used to examine the relationship of cross flow to the extent of separation. Models with strong transverse pressure gradients resulted in a diminished extent of separation about the model plane of symmetry but demonstrated expansive growth of separation to a limit with distance from the plane of symmetry. A secondary flow region was found embedded in the separated flow.

Bachalo, W. D.↗