Engineering PapersSearch

Engineering topics

Bachalo, W. D.

Publications and source records attributed to Bachalo, W. D..

At least 19 records

Liquid water content measurements using the Phase Doppler Particle Analyzer in the NASA Lewis Icing Research Tunnel

The performance of a Phase Doppler Particle Analyzer (PDPA) based icing probe suitable for use in icing tunnels and airborne applications is assessed. The instrument is shown to accurately and repeatably measure liquid water content (LWC) to within better than 20 percent of the nominal expected value in the NASA Lewis IRT. This was seen to be true over a wide range of tunnel operating conditions. The principles used by the PDPA for MVD and LWC determination are discussed. Calibration curves for the IRT median volume diameter are also determined and compared to the existing calibration determined via the PMS instruments. As has been shown in previous work, the PDPA is quite repeatable. The results are typically 3 to 5 microns smaller than the existing calibrations for a given run condition. Reasons for these differences are also discussed.

Rudoff, R. C.

Particle diagnostics and turbulence measurements in a confined isothermal liquid spray

An experimental study of the behavior and structure of a liquid spray immersed in a strong swirling field is reported. In order to simulate some of the aerodynamic conditions experienced by a spray in a model combustor, an experimental setup using an acrylic chamber, a vane-type swirler, and separate air supplies for both the secondary air and swirl air were integrated to perform the experiments in the wind tunnel. The effect of the swirling flow on the original spray cone is to widen it substantially, and to provide a vortex core where intense mixing results in large changes in particle size distribution and in particle number density. Outside the recirculation region, both the D32 and N sub d attain more uniform values. Inside the recirculation region, the mean axial velocity averaged over all the drop sizes has larger values than the mean air velocity. Outside the recirculation region, both the particles and the air exhibit virtually the same velocities. The turbulence measurements showed regions of high turbulence intensity in the boundaries of the recirculation region.

Brena De La Rosa, A.

Characterization of coaxial rocket injector sprays under high pressure environments

The effect of elevated environment pressures on the atomization characteristics of a single element, scaled-down, shear-coaxial rocket injector has been investigated. In this study, the shear coaxial injector was operated with water and air as simulants for conventionally used liquid oxygen and hydrogen gas, respectively. The experiments were conducted in a specially designed high pressure rig. A two-component PDPA/DSA system was used to study the spray characteristics at different chamber pressures ranging from atmospheric to 100 psig. The study showed an overall increase in the droplet sizes at higher chamber pressures. This phenomenon is attributed to a decrease in the secondary atomization effects at higher chamber pressures which, in turn, is directly related to a decrease in the shear experienced by the droplets as they move axially through the pressure chamber.

Sankar, S. V.

Performance of the Phase Doppler Particle Analyzer icing cloud droplet sizing probe in the NASA Lewis Icing Research Tunnel

The design, development, and testing of an icing cloud droplet sizing probe based upon the Phase Doppler Particle Analyzer (PDPA) are discussed. This probe is an in-situ laser interferometry based single particle measuring device capable of determining size distributions. The probe is designed for use in harsh environments such as icing tunnels and natural icing clouds. From the measured size distribution, Median Volume Diameter (MVD) and Liquid Water Content (LWC) may be determined. Both the theory of measurement and the mechanical aspects of the probe design and development are discussed. The MVD results from the probe are compared to an existing calibration based upon different instruments in a series of tests in the NASA Lewis Icing Research Tunnel. Agreement between the PDPA probe and the existing calibration is close for MVDs between 15 to 30 microns, but the PDPA results are considerably smaller for MVDs under 15 microns.

Rudoff, R. C.

Effects of turbulence and number density on the drag coefficient of droplets

Droplet drag coefficients for polydispersed drops are determined via the behavior of drops decelerating on the stagnation streamline of a cylinder with an afterbody mounted in a wind tunnel test section. A variety of velocity, turbulence levels, and droplet number densities were studied. A force balance equation technique was used to determine drag coefficient. For the levels of number density, up to 700/cc, and turbulence, up to about 7 percent, no definite effects were seen. However, the smallest drops in the high turbulence case showed some evidence of drop-turbulence and/or drop-drop interactions. The drag results that were developed for this set of measurements agreed well with other empirical relations previously determined.

Rudoff, R. C.

Liquid atomization by coaxial rocket injectors

The atomization characteristics of a scaled-down version of a coaxial rocket injector was investigated using a phase Doppler particle analyzer (PDPA). The injector was operated in the conventional mode with liquid being injected through its inner orifice and gas being injected through its outer annulus. The shearing action occurring at the liquid-gas interface causes the liquid jet to atomize. In this study, two different liquid-air systems, namely a water-air system and a liquid nitrogen-gaseous nitrogen system, were chosen for detailed investigation. This paper discusses the performance characteristics of the coaxial injector under different flow and geometric conditions. Specifically, the effects of injection gas pressure and the injector cavity size on variables such as the mean particle diameter, Sauter mean diameter, number density, volume flux, and velocity have been presented.

Sankar, S. V.

Spray characterization and turbulence properties in an isothermal spray with swirl

In the present experimental study of the effects of swirl on the dynamic behavior of drops and on the velocity and turbulence fields of an isothermal spray, using a two-component phase Doppler particle analyzer, mean velocity and turbulence properties were obtained for the gas phase. Large differences are noted in the spatial distribution of the drops over the spray's size, velocity, and number density, when the spray in coflowing air is compared with the atomizer spraying into the swirling flow field with the same axial velocity. The turbulence properties of the swirling flow exhibit significant influence on the dynamic behavior of the drops.

Brena De La Rosa, A.

Development of a phase Doppler based probe for icing cloud droplet characterization

The development and evaluation of a compact optical fiber probe (OFP) for airborne and wind tunnel icing cloud characterizations is described. This probe was based upon the proven phase Doppler technique for measuring the size and velocity of spherical drops. Direct comparisons of the size distributions from the standard PDPA with the OFP were used to confirm the reliability of the probe. After some improvements in the fiber coupling efficiency, the number density and liquid water content data agreed to within 15 percent.

Rudoff, R. C.

Time analysis of polydisperse sprays in complex turbulent environments

The two-phase flow field of a small swirl-stabilized burner has been investigated, using a phase Doppler particle analyzer to obtain the velocity, drop size, and time of arrival components. Water/kerosene comparisons were made for the case of nonreacting flow. It is found that the spray flow field is strongly influenced by the aerodynamic flow field and by the reaction and fluid properties. It is noted that vortex shedding produces clusters of drops.

Rudoff, R. C.

Diagnostics development for spray characterization in complex turbulent flows

The present work reports a detailed investigation of air-liquid interaction in sprays along with particle number density and mass flux measurements in complex turbulent flows such as those present in gas turbines and rocket combustors. Data have been obtained for the characterization of sprays in complex flows which include detailed drop size and drop velocity distributions, size-velocity correlations, mass flux, and particle number density. Key factors affecting the measurement of the sample volume size are discussed in detail since an accurate estimation of it is essential to the particle number density and volume flux determined by the instrument. The discrimination of refraction and reflective scattering components and their influence on the measurements are also discussed. Data comparing the phase Doppler results to alternate methods of measuring number density and volume flux are also presented. These results showed agreement to within 15 percent in most cases for realistic flow configurations.

Bachalo, W. D.

Measurements of droplet drag coefficients in a polydispersed turbulent flow field

Measurements of drag coefficient versus Reynolds number were obtained in a polydispersed turbulent flow field for three turbulence velocities and for freestream turbulence intensities between 3 and 12 percent. Results are presented for a single nozzle with low number density and a twin nozzle with higher number density. The results for drops smaller than 30 microns showed strong differences from existing low turbulence results. The drag relation was found to be weakly affected by the freestream velocity and to be strongly affected by the velocity fluctuation levels of individual size classes. A drag effect with the drop-drop interaction may also be possible.

Rudoff, R. C.

Analysis of the light scattering interferometry for spheres larger than the light wavelength

A theoretical model, based on the geometrical optics approach, has been developed to simulate various aspects of the phase Doppler particle analyzer (PDPA). The model has taken into consideration the non-uniform (Gaussian) illumination of the particles as they pass through the probe volume. Instrument response curves have been generated for various scattering angles by performing spatial and temporal integration of the scattered intensity distribution over the receiver surface. Experimental and theoretical investigations have established the applicability of this instrument to both forward and backscatter angles.

Bachalo, W. D.

Optical interferometry in fluid dynamics research

Optical interferometry techniques were applied to the investigation of transonic airfoil flow fields in large wind tunnels. Holographic interferometry techniques were used to study 2 dimensional symmetric NACA 64A010 and Douglas Aircraft Co. DSMA671 supercritical airfoil performance in the NASA Ames 2 x 2 ft transonic wind tunnel. Quantitative data obtained from the interferograms were compared to the surface pressure data. The agreement obtained verified the accuracy of the flow visualization and demonstrated the potential for acquiring quantitative scalar results. Measurements of the inviscid flow speed and the boundary layer and wake velocity profiles were extracted from the interferograms and compared to laser Doppler velocimeter measurements. These results were also in good agreement. A method for acquiring real time interferometric data in large scale facilities was developed. This method, based on the point diffraction interferometer, was successfully tested in the 2 x 2 ft transonic wind tunnel. The holographic and real time interferometry methods were applied to the investigations of circulation control airfoils utilizing the Coanda effect. These results reveals the details of the jet interacting with the trailing edge boundary layer and the other parameters affecting the lift augmentation.

Bachalo, W. D.

Experiments on spray interactions in the wake of a bluff body

The dynamics of spray drop interaction within the turbulent wake of a bluff body were investigated using the Aerometrics Phase Doppler Particle Analyzer that determines both drop size and velocity. Detailed measurements obtained included spray drop size, axial and radial velocity, angle of trajectory, and size-velocity correlations. The gas-phase flow field was also ascertained via the behavior of the smallest drops. Results showed dramatic differences in drop behavior when interacting with turbulence for the various size classes. Small drops were recirculated in a pair of toroidal vortices located behind the bluff body, whereas the larger drops followed the general direction of the spray cone angle. The spray field interaction illustrated by these data casts some doubt on attempts to describe sprays via simple integral quantities such as the Sauter mean diameter.

Rudoff, R. C.

Two-phase flow measurements of a spray in a turbulent flow

The dynamics of spray drop interaction with a turbulent coflowing air stream were investigated using a Phase Doppler Particle Analyzer that determines both drop size and velocity. Detailed measurements obtained included spray drop size, axial and radial velocity, angle of trajectory, drop Reynolds number, and size-velocity correlations. The gas-phase flow field was also ascertained via the behavior of the smallest drops. Also investigated were the drag coefficients of droplets in a turbulent air cross flow for both monodispersions and polydispersions. Most notable aspects of the coflow included the effect of air streams with velocities significantly different from the spray sheet. Local changes in number density were produced as a result of lateral convection and streamwise accelerations and decelerations of various drop size classes. The complexity of the spray field interaction illustrated by this data effectively describes the development of the spray due to the influence of the airflow. The droplet drag measurements showed similar behavior for monodispersed and polydispersed flows and similar trends to previously obtained data. The measurements also pointed out further studies which would assist in creating an improved drag law for polydispersed drops in a turbulent environment.

Rudoff, R. C.

Laser velocimetry in turbulent flow fields - Particle response

Measurements of the particle response in a decelerating flow and a highly turbulent two-phase flow were obtained. Simultaneous measurements of the particle size and velocity served to quantify the particle response to the prevailing flow field. In the case of a flow incident upon a cylinder, the particle lag for a range of size classes was recorded. Results were also obtained in the flow generated by an atomizer operating on the leeward side of a flat disk bluff body in a coflowing air stream. Measurements of the mean axial, mean radial, and rms velocities and angles of trajectories were obtained for representative particle size classes. The air velocity and turbulence intensity were inferred from the seed particles on the order of one micrometer in diameter. Particles 9 micrometers and larger showed significant differences with respect to the gas phase mean velocity and turbulence intensity even at low velocities. In two-phase flows, reliable measurements of the continuous phase velocity and turbulence parameters requires the simultaneous measurement of particle size as a means for rejecting readings from large particles from the velocity pdf's.

Bachalo, W. D.

Two-phase measurements of a spray in the wake of a bluff body

The dynamics of spray drop interaction with the turbulent, recirculating wake of a flat disk bluff body were investigated using a phase Doppler particle analyzer to determine drop size and velocity and the gas-phase velocity. Detailed measurements obtained included spray drop size, axial and radial velocity, angle of trajectory, and size-velocity correlations. The gas-phase velocity was determined from seeding of the two-phase flow. Results showed dramatic differences in drop behavior for various size classes when interacting with the turbulent flow field. Small drops were quickly entrained and recirculated, while initially, the larger drops continued in the general direction of the spray cone. Further downstream, significant numbers of large drops recirculated, generating a bifurcated size-velocity correlation. These lateral convections and streamwise accelerations and decelerations strongly influenced the number density along with size and velocity distributions. The complex interaction of the spray with the turbulent air-flow points out the need for spatially-resolved measurements that determine drop behavior for individual size classes, rather than characterizing a spray only via simple integral quantities such as the Sauter mean diameter.

Rudoff, R. C.

Spray drop size and velocity measurements using the Phase/Doppler Particle Analyzer

Detailed measurements of the drop size and velocity distributions were obtained for a swirl chamber pressure atomizer. These data were obtained with the Phase/Doppler Particle Analyzer manufactured by Aerometrics, Inc. Direct measurements of the size distributions revealed the evolving characteristics of the spray. Size velocity correlations were used to evaluate the effect of velocity relaxation on the size distributions. The simultaneous measurement of drop size and velocity was of major importance in accurately describing the changes in the local drop size distributions and mass flux.

Bachalo, W. D.