Engineering Papers⌕ Search

Engineering topics

Alderman, O. L. G.

Publications and source records attributed to Alderman, O. L. G..

15 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2019

Short-Range Disorder in TeO 2 Melt and Glass

High-resolution X-ray pair distribution functions for molten and glassy TeO 2 reveal coordination numbers n TeO ≈ 4. However, distinct from the known α-, β-, and γ-TeO 2 polymorphs, there is considerable short-range disorder such that no clear cutoff distance between bonded and nonbonded interactions exists. We suggest that this is similar to disorder in δ-TeO 2 and arises from a broad distribution of asymmetric Te–O–Te bridges, something that we observe becomes increasingly asymmetric with increasing liquid temperature. Such behavior is qualitatively consistent with existing interpretations of Raman scattering spectra, and equivalent to temperature-induced coordination number reduction, for sufficiently large cutoff radii. Therefore, TeO 2 contains a distribution of local environments that are, furthermore, temperature dependent, making it distinct from the canonical single-oxide glass formers. Furthermore, our results are in good agreement with high-level ab initio cluster calculations.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2019

Molten barium titanate: a high-pressure liquid silicate analogue

The structure of molten BaTiO 3 has been calculated using laser heating, aerodynamic levitation and a combination of neutron diffraction with Ti isotope substitution, x-ray diffraction and spectroscopy. All measurements indicate a Ti-O coordination of n TiO = 4.4(2), far lower than the perovskite or hexagonal crystalline forms. Yet, n TiO > 4 suggests structural analogy with molten silicates at high pressures. We introduce methodology for ascertaining such analogies and demonstrate similarity with molten CaSiO 3 at upper mantle pressures circa 5 GPa. While some topological differences exist, we postulate that planetary melt analogues provide rich insight into important processes relevant to hot exoplanets and Earth's early history.

36 MATERIALS SCIENCE↗
DOE OSTI2018

Corium lavas: structure and properties of molten UO 2 -ZrO 2 under meltdown conditions

In the exceedingly rare event of nuclear reactor core meltdown, uranium dioxide fuel reacts with Zircaloy cladding to produce eutectic melts which can subsequently be oxidized by coolant/moderator water. Oxidized corium liquids in the xUO 2 ·(100 – x)ZrO 2 system were produced via laser melting of UO 2 -ZrO 2 mixtures to temperatures in excess of 3000 K. Contamination was avoided by floating the droplets on a gas stream within an aerodynamic levitator and in-situ high-energy x-ray diffraction experiments allowed structural details to be elucidated. Molecular dynamics simulations well reproduced diffraction and density data, and show less compositional variation in thermal expansion and viscosity than suggested by existing measurements. As such, corium liquids maintain their highly penetrating nature irrespective of the amount of oxidized cladding dissolved in the molten fuel. Metal-oxygen coordination numbers vary with both composition and temperature. The former is due to mismatch in native values, n UO (x = 100) ≈ 7 and n ZrO (x = 0) ≈ 6, and the requirement for oxygen site stabilization. Furthermore, the latter provides a thermal expansion mechanism.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗
DOE OSTI2017

The structure of liquid alkali nitrates and nitrites

State of the art high energy X-ray diffraction experiments and simulation models (employing a description of charge transfer) are applied to pure molten alkali nitrates and nitrites and uncover significant emerging structure.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2017

The structure of liquid UO 2-x in reducing gas atmospheres

High energy X-ray diffraction experiments performed on hypostoichiometric UO 2-x liquids in reducing gas mixtures of 95%Ar:5%CO and 95%Ar:5%H 2 are compared to that conducted in a pure Ar atmosphere [Skinner et al., Science 346, 984 (2014)]. The measurements are pertinent to severe accident scenarios at nuclear reactors, where core melts can encounter reducing conditions and further shed light on the oxide chemistry of the low valence states of uranium, particularly U(III), which become stable only at very high temperatures and low oxygen potentials. The radioactive samples were melted by floating small spheres of material using an aerodynamic levitator and heating with a laser beam. In the more reducing environments, a 1.7% shift to lower Q-values is observed in the position of the principal peak of the measured X-ray structure factors, compared to the more oxidizing Ar environment. This corresponds to an equivalent elongation in the U-U nearest neighbor distances and the U-U periodicity. The U-O peak (modal) bond-length, as measured from the real-space total correlation functions, is also observed to expand by 0.9–1.6% under reducing conditions, consistent with the presence of 15–27% U 3+ cations, assuming constant U-O coordination number. The slightly larger U-U elongation, as compared to the U-O elongation, is interpreted as a slight increase in U-O-U bond angles. Difficulties concerning the determination of the hypostoichiometry, x, are discussed, along with the future directions for related research.

54 ENVIRONMENTAL SCIENCES↗
DOE OSTI2017

Iron K-edge X-ray absorption near-edge structure spectroscopy of aerodynamically levitated silicate melts and glasses

Here, the local structure about Fe(II) and Fe(III) in silicate melts was investigated in-situ using iron K-edge X-ray absorption near-edge structure (XANES) spectroscopy. An aerodynamic levitation and laser heating system was used to allow access to high temperatures without contamination, and was combined with a chamber and gas mixing system to allow the iron oxidation state, Fe 3+ /ΣFe, to be varied by systematic control of the atmospheric oxygen fugacity. Eleven alkali-free, mostly iron-rich and depolymerized base compositions were chosen for the experiments, including pure oxide FeO, olivines (Fe,Mg) 2 SiO 4 , pyroxenes (Fe,Mg)SiO 3 , calcic FeO-CaSiO 3 , and a calcium aluminosilicate composition, where total iron content is denoted by FeO for convenience. Melt temperatures varied between 1410 and 2160 K and oxygen fugacities between FMQ – 2.3(3) to FMQ + 9.1(3) log units (uncertainties in parentheses) relative to the fayalite-magnetite-β-quartz (FMQ) buffer.

36 MATERIALS SCIENCE↗
DOE OSTI2016

Continuous Structural Transition in Glass-Forming Molten Titanate BaTi 2 O 5

The structure of the model titanate glass former BaTi2O5 has been studied over a wide temperature (T) range in the molten, supercooled, and glassy states under conditions of aerodynamic levitation. Both high-energy X-ray diffraction and Ti K-edge X-ray absorption spectroscopy reveal a continuous structural transition involving reduction of the cation-oxygen (and oxygen-cation) average coordination numbers and bond lengths with increasing T. Ti-0 coordination in the moderately supercooled and equilibrium melt follows a linear trend n(Tio) = 5.4(1)- [3.5(7) x 10(-4)]T [K] (1300 <= T <= 1830 K, T-g = 960 K, T-m = 1660 K). Comparison to the melt-quenched glass implies an increase in partial derivative n(Tio)/partial derivative T at lower T, as T-g is approached from above. Both Ba-0 coordination and bond length also decrease at higher T, and the role of Ba addition is to reduce n(Tio) below its value in pure molten TiO2, which is related to the presence of density maxima in molten BaO-TiO2. Density measurements made by imaging of the levitated melt yielded rho(T) = 4.82(55)- 0.0004(3)T in units of K and g cm(-3). While BaTi2O5 glass likely consists of a fully connected Ti-0 network, free of nonbridging oxygen (NBO) [OTi1 and with at least 13(4)% [OTi3] triclusters, the 1835(40) K equilibrium melt contains at least 10(4)% NBO along with 90(4)% bridging oxygen [OTi2]. The results highlight the fact that glasses can be considered as structural analogues of melts only for those melts deeply supercooled into the glass transition region. The results imply possible fictive T dependence of titanate glass structure, suggesting applications as, e.g., laser written waveguides with large refractive indices and refractive index contrasts. The temperature-dependent structure further implies a super-Arrhenian melt viscosity with consequences for glass manufacture, titanate-rich slags produced in iron smelting, TiO2-bearing magmas, and by analogy silicate melts at high pressures, as found in planetary interiors.

36 MATERIALS SCIENCE↗
DOE OSTI2016

Thermal expansion in UO 2 determined by high-energy X-ray diffraction

Here we present crystallographic analyses of high-energy X-ray diffraction data on polycrystalline UO2 up to the melting temperature. The Rietveld refinements of our X-ray data are in agreement with previous measurements, but are systematically located around the upper bound of their uncertainty, indicating a slightly steeper trend of thermal expansion compared to established values. This observation is consistent with recent first principles calculations.

Guthrie, M.↗
DOE OSTI2016

Aerodynamic levitator for in situ x-ray structure measurements on high temperature and molten nuclear fuel materials

An aerodynamic levitator with carbon dioxide laser beam heating was integrated with a hermetically sealed controlled atmosphere chamber and sample handling mechanism. The system enabled containment of radioactive samples and control of the process atmosphere chemistry. The chamber was typically operated at a pressure of approximately 0.9 bars to ensure containment of the materials being processed. Samples 2.5-3 mm in diameter were levitated in flowing gas to achieve containerless conditions. Levitated samples were heated to temperatures of up to 3500 °C with a partially focused carbon dioxide laser beam. Sample temperature was measured using an optical pyrometer. The sample environment was integrated with a high energy (100 keV) x-ray synchrotron beamline to enable in situ structure measurements to be made on levitated samples as they were heated, melted, and supercooled. The system was controlled from outside the x-ray beamline hutch by using a LabVIEW program. Measurements have been made on hot solid and molten uranium dioxide and binary uranium dioxide-zirconium dioxide compositions.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2015

Note: Detector collimators for the nanoscale ordered materials diffractometer instrument at the Spallation Neutron Source

Five neutron collimator designs were constructed and tested at the nanoscale ordered materials diffractometer (NOMAD) instrument. Collimators were made from High Density PolyEthylene (HDPE) or 5% borated HDPE. In all cases, collimators improved the signal to background ratio and reduced detection of secondary scattering. In the Q-range 10-20 Å{sup −1}, signal to background ratio improved by factors of approximately 1.6 and 2.0 for 50 and 100 mm deep collimators, respectively. In the Q-range 40-50 Å{sup −1}, the improvement factors were 1.8 and 2.7. Secondary scattering as measured at Q ∼ 9.5 Å{sup −1} was significantly decreased when the collimators were installed.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗