Engineering topics

Ahmed, S. A.

Publications and source records attributed to Ahmed, S. A..

8 records

NASA NTRS1986

Concentration distributions in a model combustor

A hot-wire concentration probe with a spatial resolution of 0.13 mm is used to measure concentration in a model cylindrical combustor. The flow inside the combustor is simulated by injecting a helium jet into a cylindrical confinement with or without swirling air flow present. Mean concentrations are essentially zero outside of the jet region, indicating complete confinement of the scalar field by the swirling flow. Consequently, concentration fluctuations are found to be relatively weak compared to velocity fluctuations, and are maximum off-axis at a point which corresponds to the interface between helium and air flows. However, in the absence of a swirling air flow, the helium diffuses quickly to fill the combustor. The resulting helium concentrations are constant and do not resemble the jet-like behavior of the velocity field.

Ahmed, S. A.↗

NASA NTRS1985

Behavior of turbulent gas jets in an axisymmetric confinement

The understanding of the mixing of confined turbulent jets of different densities with air is of great importance to many industrial applications, such as gas turbine and Ramjet combustors. Although there have been numerous studies on the characteristics of free gas jets, little is known of the behavior of gas jets in a confinement. The jet, with a diameter of 8.73 mm, is aligned concentrically in a tube of 125 mm diameter, thus giving a confinement ratio of approximately 205. The arrangement forms part of the test section of an open-jet wind tunnel. Experiments are carried out with carbon dioxide, air and helium/air jets at different jet velocities. Mean velocity and turbulence measurements are made with a one-color, one-component laser Doppler velocimeter operating in the forward scatter mode. Measurements show that the jets are highly dissipative. Consequently, equilibrium jet characteristics similar to those found in free air jets are observed in the first two diameters downstream of the jet. These results are independent of the fluid densities and velocities. Decay of the jet, on the other hand, is a function of both the jet fluid density and momentum. In all the cases studied, the jet is found to be completely dissipated in approximately 30 jet diameters, thus giving rise to a uniform flow with a very high but constant turbulence field across the confinement.

So, R. M. C.↗

NASA NTRS1985

Jet characteristics in confined swirling flow

Jets in confined swirling flow are investigated in a facility where the swirling flow in the tube is produced by a vane-type swirler. The jet is located centrally in the swirler, and the diameter ratio of the tube to the jet is about 14. Both the jet and the swirling flow are fully turbulent. Results show that the confined jet is highly dissipative in nature. Consequently, the flow in the tube does not resemble a free jet with axial pressure gradient. The presence of swirl increases the rate of dissipation and the jet decays even faster. A fairly isotropic turbulence field is observed in the confined swirling flow. However, the introduction of the jet does not significantly affect this behavior, and near isotropy of the turbulence field is again observed at about 30 jet diameters downstream.

So, R. M. C.↗

NASA NTRS1985

Density effects on jet characteristics in confined swirling flow

Density effects on isothermal jet mixing in confined swirling flow are investigated. The experiment is carried out with helium/air as the jet fluid in the same facility as that used by So et al. (1984) and the test conditions are chosen to be the same as before. Contrary to the homogeneous mixing results, the helium jet is preserved up to 40 jet diameters downstream. The behavior of the mean and turbulence field depends highly on the initial jet velocity. Since the jets are fully turbulent and the jet momentum fluxes for inhomogeneous mixing are less than those for homogeneous mixing, the cause of this difference in behavior is directly attributed to the combined action of density difference and swirl. In spite of this, near isotropy of the turbulence field is again observed at about 40 jet diameters downstream.

Ahmed, S. A.↗

NASA NTRS1984

An experimental investigation of gas jets in confined swirling air flow

The fluid dynamics of jets in confined swirling flows which is of importance to designers of turbine combustors and solid fuel ramjets used to power missiles fired from cannons were examined. The fluid dynamics of gas jets of different densities in confined swirling flows were investigated. Mean velocity and turbulence measurements are made with a one color, one component laser velocimeter operating in the forward scatter mode. It is shown that jets in confined flow with large area ratio are highly dissipative which results in both air and helium/air jet centerline velocity decays. For air jets, the jet like behavior in the tube center disappears at about 20 diameters downstream of the jet exit. This phenomenon is independent of the initial jet velocity. The turbulence field at this point also decays to that of the background swirling flow. A jet like behavior in the tube center is noticed even at 40 diameters for the helium/air jets. The subsequent flow and turbulence field depend highly on the initial jet velocity. The jets are fully turbulent, and the cause of this difference in behavior is attributed to the combined action swirl and density difference. This observation can have significant impact on the design of turbine combustors and solid fuel ramjets subject to spin.

Mongia, H.↗

NASA NTRS1984

Characteristics of inhomogeneous jets in confined swirling air flows

An experimental program to study the characteristics of inhomogeneous jets in confined swirling flows to obtain detailed and accurate data for the evaluation and improvement of turbulent transport modeling for combustor flows is discussed. The work was also motivated by the need to investigate and quantify the influence of confinement and swirl on the characteristics of inhomogeneous jets. The flow facility was constructed in a simple way which allows easy interchange of different swirlers and the freedom to vary the jet Reynolds number. The velocity measurements were taken with a one color, one component DISA Model 55L laser-Doppler anemometer employing the forward scatter mode. Standard statistical methods are used to evaluate the various moments of the signals to give the flow characteristics. The present work was directed at the understanding of the velocity field. Therefore, only velocity and turbulence data of the axial and circumferential components are reported for inhomogeneous jets in confined swirling air flows.

So, R. M. C.↗

NASA NTRS1984

Concentration distributions in cylindrical combustors

Experimental studies have been conducted with the aim to obtain a better understanding of the fluid dynamics of mixing in gas turbine combustors, and solid fuel ramjet combustors subject to spin. The present investigation represents a continuation of studies conducted by So et al. (1984). It is also concerned with the verification of some conclusions reported by Ahmed et al. (1984). Attention is given to the experimental facility and instrumentation, centerline concentration measurements, mean concentration profiles, and a comparison of concentration and axial velocity results in the case of swirling flow.

Ahmed, S. A.↗

NASA NTRS1973

Determination of Spatial Distribution of Air Pollution by Dye Laser Measurement of Differential Absorption of Elastic Backscatter

This paper presents the results of an analytical study of a lidar system which uses tunable organic dye lasers to accurately determine spatial distribution of molecular air pollutants. Also described will be experimental work to date on simultaneous multiwavelength output dye laser sources for this system. Basically the scheme determines the concentration of air pollutants by measuring the differential absorption of an (at least) two wavelength lidar signal elastically backscattered by the atmosphere. Only relative measurements of the backscattered intensity at each of the two wavelengths, one on and one off the resonance absorption of the pollutant in question, are required. The various parameters of the scheme are examined and the component elements required for a system of this type discussed, with emphasis on the dye laser source. Potential advantages of simultaneous multiwavelength outputs are described. The use of correlation spectroscopy in this context is examined. Comparisons are also made for the use of infrared probing wavelengths and sources instead of dye lasers. Estimates of the sensitivity and accuracy of a practical dye laser system of this type, made for specific pollutants, snow it to have inherent advantages over other schemes for determining pollutant spatial distribution.

Ahmed, S. A.↗