Engineering topics

Ahmed, A.

Publications and source records attributed to Ahmed, A..

24 records · Page 2

NASA NTRS1990

Decentralized control experiments on the JPL flexible spacecraft

Decentralized control experiments were successfully demonstrated for the JPL/AFAL Flexible Structure. A simulation package using MATRIXx showed strong correlation between the simulations and experimental result, while providing a means for test and debug of the various control strategies. Implementation was simplified by a modular software design that was easily transported from the simulation environment to the experimental environment. Control designs worked well for suppression of the dominant modes of the structure. Static decentralized output feedback dampened the excited modes of the structure, but sometimes excited higher order modes upon startup of the controller. A second-order frequency shaping controller helped to eliminate excitation of the higher order modes by attenuating high frequencies in the control effort. However, it also resulted in slightly longer settling times.

Ozguner, U.↗

NASA NTRS1989

Experiments in multivariable adaptive control of a large flexible structure

A six-input/six-output multivariable adaptive controller is used to control a large 3-dimensional flexible structure experiment. For this purpose, the JPL/AFAL antenna-like experiment structure is used, with instrumentation distributed on both the hub and the ribs. This represents a significant increase in complexity relative to earlier adaptive control experiments performed on the same structure, utilizing a two-input/two-output set-up with instrumentation on the hub alone. The increase in instrumentation significantly increases spatial controllability, and excitation and control of a much larger set of modes. This paper documents multivariable adaptive control experiments on this structural configuration, and discusses many of the associated design and implementation issues required for successful operation.

Ih, C.-H. C.↗

NASA NTRS1985

Further results of natural laminar flow flight test experiments

Flight test experiments were conducted to measure the extent and nature of natural laminar flow on a smoothed test region of a swept-wing business jet wing. Surface hot film anemometry and sublimating chemicals were used for transition detection. Surface pressure distributions were measured using pressure belts. Engine noise was monitored by a microphone attached to the wing surface to study possible acoustic effects on stability of the laminar boundary layer. Side-slip conditions were flown to simulate changes in effective wing sweep. Flight instrumentation and ground data analysis techniques and a method for measuring intermittency of turbulence are described. Correlation was obtained between the hot film gage signals and chemicals for transition detection. Cross-flow vortices were observed for some flight conditions. Results of spectral and statistical analysis of the hot film signals for various flight test conditions are presented.

Wentz, W. H., Jr.↗

NASA NTRS1984

Natural laminar flow flight experiments on a swept-wing business jet

Flight test experiments have been conducted to measure the extent and nature of laminar flow on a smoothed test region of a swept-wing business jet. Surface hot film anemometers and sublimating chemicals were used for transition detection. Surface pressure distributions were measured using pressure belts. Instrumentation techniques and problems are presented. Correlation was obtained between the hot film and sublimating chemicals for transition detection. Taylor-Goertler vortices were observed for some flight conditions. Boundary layer stability analysis is being conducted using measured pressure distributions to determine the correlation possible for transition prediction on swept wings.

Wentz, W. H., Jr.↗

NASA NTRS1982

Equivalence of the generalized Lie-Hori method and the method of averaging

In this investigation, a comparison is made of two methods for developing perturbation theories for non-canonical dynamical systems. The methods compared are the generalized Lie-Hori method and the method of averaging. In the comparison presented here, the equivalence of the methods up to the second order in the small parameter is shown. However, the approach used can be extended to demonstrate the equivalence for higher orders. To illustrate the equivalence both Duffing's equation and the van der Pol equation are solved using each method.

Ahmed, A.↗

NASA NTRS1982

3-D supersonic combustion experiments with hydrogen in V-trough

Both supersonic blowdown and free jet wind tunnels were used in oil flow visualization and hydrogen gas burning tests of 60- and 90-deg V-shaped trough combustion characteristics. Oil dots showed that mass outflow from the reattachment region at the bottom of the V-trough dominated flow behavior, and occupied the trough's entire length and 10% of its cross-section. Intermingled vortex pairs were also found to superimpose themselves upon the outflow, and hydrogen burning within troughs reduced missile base drag by 25%. The troughs were aligned so that their long dimensions were parallel to the airflow, and the two top edges of the V section were mounted flush with respect to the upstream flat surfaces. Step heights tested ranged from 3.4 mm to 6.25 cm.

Friedberg, R. A.↗