Engineering Papers⌕ Search

Engineering topics

Abraham, D P

Publications and source records attributed to Abraham, D P.

Differential voltage analyses of high-power lithium-ion cells 4. Cells containing NMC.

Cells with and without a LiC{sub 2}O{sub 4}BF{sub 2} electrolyte additive and that contained Li{sub 1.05}(Mn{sub 1/3}Co{sub 1/3}Ni{sub 1/3}){sub 0.95}O{sub 2} (NMC) positive electrodes were tested for calendar and cycle life at 60% state of charge. The temperatures used in these tests were 25 and 45 C (cycle life) and 45 and 55 C (calendar life). An analysis of the C/25 capacity data shows that the C/25 capacity decreases with the square root of time. The additive slowed down the rate of capacity decline. The C/25 data were subjected to differential voltage analysis to determine the possible cause of the capacity decrease and at which electrode the capacity decrease was occurring. Data from full cells and half-cells were compared to elucidate individual electrode contributions. This analysis indicated that lithium-capacity-consuming side reactions were occurring primarily at the negative electrode.

25 ENERGY STORAGE↗

Analysis of the Galvanostatic Intermittent Titration Technique (GITT) as applied to a lithium-Ion porous electrode.

Galvanostatic Intermittent Titration Technique (GITT) experiments were conducted to determine the lithium diffusion coefficient of LiNi{sub 0.8}Co{sub 0.15}Al{sub 0.05}O{sub 2}, used as the active material in a lithium-ion battery porous composite positive electrode. An electrochemical model, based on concentrated solution porous electrode theory, was developed to analyze the GITT experimental results and compare to the original GITT analytical theory. The GITT experimental studies on the oxide active material were conducted between 3.5 and 4.5 V vs. lithium, with the maximum lithium diffusion coefficient value being 10{sup -10} cm{sup 2} s{sup -1} at 3.85 V. The lithium diffusion coefficient values obtained from this study agree favorably with the values obtained from an earlier electrochemical impedance spectroscopy study.

25 ENERGY STORAGE↗

Examining the solid electrolyte interphase on binder-free graphite electrodes.

The solid electrode interphase (SEI) on graphite electrodes is important to the performance, calendar life, and safety characteristics of lithium-ion cells. This article examines the SEI formed on binder-free graphite electrodes prepared by electrophoretic deposition. X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis data were obtained on electrodes cycled in cells containing four electrolytes comprising ethylene carbonate: ethylmethyl carbonate (3:7 by weight) solvent and 1.2 M LiPF{sub 6}, 1 M LiF{sub 2}BC{sub 2}O{sub 4}, 1 M LiBF{sub 4}, or 0.7 M LiB(C{sub 2}O{sub 4}){sub 2} salt. Our observations suggest that, in addition to solvent reduction, the reduction of electrolyte salts plays an important role in SEI formation. Mechanisms to account for the formation of these SEI constituents are included in the article.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

First-cycle irreversibility of layered Li-Ni-Co-Mn oxide cathode in Li-ion batteries.

The first-cycle irreversibility of Li{sub 1.048}(Ni{sub 1/3}Co{sub 1/3}Mn{sub 1/3}){sub 0.952}O{sub 2} (LiMO{sub 2}) cathode material in lithium and lithium-ion cells has been studied using galvanostatic cycling and in situ synchrotron X-ray diffraction. The so-called 'lost capacity' of a Li/LiMO{sub 2} cell observed during initial cycle in conventional voltage ranges (e.g., 3.0-4.3 V) could be completely recovered by discharging the cell to low voltages (<2 V). During the deep discharge, the lithium cell exhibited an additional voltage plateau, which is believed to result from the formation of Li{sub 2}MO{sub 2}-like phase on the oxide particle surface due to very sluggish lithium diffusion in Li{sub 1-{Delta}}MO{sub 2} with {Delta} {yields} 0 (i.e., near the end of discharge). Voltage relaxation curve and in situ X-ray diffraction patterns, measured during relaxation of the lithium cell after deep discharge to obtain 100% cycle efficiency, suggested that the oxide cathode returned to its original state after the following two-step relaxation processes: relatively quick disappearance of the Li{sub 2}MO{sub 2}-like phase on the particle surface, followed by slow lithium diffusion in the layered structure. Experiments conducted in Li{sub 4}Ti{sub 5}O{sub 12}/LiMO{sub 2} lithium-ion cells confirmed that the physical loss of lithium (via surface film formation or parasitic electrochemical reactions, etc.) from LiMO{sub 2} was negligible up to an oxide voltage of 4.3 V vs. Li{sup +}/Li.

43 PARTICLE ACCELERATORS↗

Local structure and composition studies of Li{sub 1.2}Ni{sub 0.2}Mn{sub 0.6}O{sub 2} by analytical electron microscopy.

Positive electrodes for Li-ion batteries based on Li[Li{sub 1/3-2x/3}Ni{sub x}Mn{sub 2/3-x/3}]O{sub 2} (0 {le} x {le} 0.5) compounds are of significant interest because of their ability to deliver reversible capacities exceeding 200 mAh g{sup -1}. In this article we describe the examination of Li{sub 1.2}Ni{sub 0.2}Mn{sub 0.6}O{sub 2} (x = 0.2 in Li[Li{sub 1/3-2x/3}Ni{sub x}Mn{sub 2/3-x/3}]O{sub 2}) samples by X-ray diffraction (XRD), high-resolution electron microscopy (HREM), scanning transmission electron microscopy (STEM), electron diffraction, X-ray energy dispersive spectroscopy (EDS), and electron energy loss spectroscopy (EELS). The studies were conducted on freshly prepared oxides, and on oxide electrodes that were electrochemically activated by cycling twice between 4.8 and 2.0 V vs. Li{sup +}/Li. Rectangular and parallelogram shaped dot arrays with a spacing of 0.43 nm observed in HREM and STEM images along the [10{bar 1}0] zone axis, as well as streaks at 1/3 n (11{bar 2}0) (n = integer) positions in corresponding electron diffraction patterns, indicated ordering of Li-ions in the transition-metal (TM) (0 0 0 1) layers following several stacking sequences, bounded by stacking faults, along the c-axis. Chemical analysis by EDS and EELS showed that Mn, Ni and O were present in all portions of the samples examined; no evidence of elemental segregation was observed either within the grains or at grain boundaries. The Li ordering on TM planes was significantly weaker but still discernable upon electrochemical activation of the oxide samples.

25 ENERGY STORAGE↗

Eeffect of electrolyte composition on initial cycling and impedance characteristics of lithium-ion-cells.

Hybrid-electric vehicles require lithium-battery electrolytes that form stable, low impedance passivation layers to protect the electrodes, while allowing rapid lithium-ion transport under high current charge/discharge pulses. In this article, we describe data acquired on cells containing LiNi{sub 0.8}Co{sub 0.15}Al{sub 0.05}O{sub 2}-based positive electrodes, graphite-based negative electrodes, and electrolytes with lithium hexafluorophosphate (LiPF{sub 6}), lithium tetrafluoroborate (LiBF{sub 4}), lithium bis(oxalato)borate (LiBOB) and lithium difluoro(oxalato) borate (LiF{sub 2}OB) salts. The impedance data were collected in cells containing a Li-Sn reference electrode to determine effect of electrolyte composition and testing temperature on individual electrode impedance. The full cell impedance data showed the following trend: LiBOB > LiBF{sub 4} > LiF{sub 2}OB > LiPF{sub 6}. The negative electrode impedance showed a trend similar to that of the full cell; this electrode was the main contributor to impedance in the LiBOB and LiBF{sub 4} cells. The positive electrode impedance values for the LiBF{sub 4}, LiF{sub 2}OB, and LiPF{sub 6} cells were comparable; the values were somewhat higher for the LiBOB cell. Cycling and impedance data were also obtained for cells containing additions of LiBF{sub 4}, LiBOB, LiF{sub 2}OB, and vinylene carbonate (VC) to the EC:EMC (3:7 by wt.) + 1.2 M LiPF{sub 6} electrolyte. Our data indicate that the composition and morphology of the graphite SEI formed during the first lithiation cycle is an important determinant of the negative electrode impedance, and hence full cell impedance.

36 MATERIALS SCIENCE↗

Investigating the low-temperature impedance increase of lithium-ion cells.

Low-temperature performance loss is a significant barrier to commercialization of lithium-ion cells in hybrid electric vehicles. Increased impedance, especially at temperatures below 0 C, reduces the cell pulse power performance required for cold engine starts, quick acceleration, or regenerative braking. Here we detail electrochemical impedance spectroscopy data on binder- and carbon-free layered-oxide and spinel-oxide electrodes, obtained over the +30 to ?30 C temperature range, in coin cells containing a lithium-preloaded Li{sub 4/3}Ti{sub 5/3}O{sub 4} composite (LTOc) counter electrode and a LiPF{sub 6}-bearing ethylene carbonate/ethyl methyl carbonate electrolyte. For all electrodes studied, the impedance increased with decreasing cell temperature; the increases observed in the midfrequency arc dwarfed the increases in ohmic resistance and diffusional impedance. Our data suggest that the movement of lithium ions across the electrochemical interface on the active material may have been increasingly hindered at lower temperatures, especially below 0 C. Low-temperature performance may be improved by modifying the electrolyte-active material interface (for example, through electrolyte composition changes). Increasing surface area of active particles (for example, through nanoparticle use) can lower the initial electrode impedance and lead to lower cell impedances at -30 C.

74 ATOMIC AND MOLECULAR PHYSICS↗

Evidence of transition-metal accumulation on aged graphite anodes by SIMS.

In cells containing Li{sub 1.05}(Ni{sub 1/3}Co{sub 1/3}Mn{sub 1/3}){sub 0.95}O{sub 2}-based positive and graphite-based negative electrodes, a significant portion of cell impedance rise on aging is known to be from the negative electrode. One possible reason for this impedance rise is the dissolution of transition-metal elements from the oxide electrode that accumulate and create a high-impedance layer at the negative electrode-electrolyte interface. This article details dynamic secondary ion mass spectrometry (SIMS) measurements, which provide a relative comparison of Mn, Co, and Ni contents on fresh, formed, and aged graphite electrodes. The data clearly indicate that these transition-metal elements accumulate at the electrode surface and diffuse into the electrode during cell aging.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗