Measurement of the t¯t Z and t¯t W cross sections in proton-proton collisions at √ s = 13 TeV with the ATLAS detector
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Abeloos, B..
Explore the source record for details and available documents.
A study of the decays B s 0 → μ + μ – and B 0 → μ + μ – has been performed using 26.3 fb –1 of 13 TeV LHC proton-proton collision data collected with the ATLAS detector in 2015 and 2016. Since the detector resolution in μ + μ – invariant mass is comparable to the B s 0 -B 0 mass difference, a single fit determines the signal yields for both decay modes. This results in a measurement of the branching fraction B(B s 0 → μ + μ – ) = (3.2 +1.1 –1.0 ) × 10 –9 and an upper limit B(B 0 → μ + μ – ) < 4.3×10 –10 at 95% confidence level. The result is combined with the Run 1 ATLAS result, yielding B(B s 0 → μ + μ – ) = (2.8 +0.8 –0.7 ) × 10 –9 and B(B 0 → μ + μ – ) < 2.1 × 10 –10 at 95% confidence level. The combined result is consistent with the Standard Model prediction within 2.4 standard deviations in the B(B 0 → μ + μ – ) – B(B 0 s → μ + μ – ) plane.
Not Available
A search for Higgs boson pair production in the $ b\overline{b}W{W}^{*} $ decay mode is performed in the $ b\overline{b}$ℓνqq final state using 36.1 fb –1 of proton-proton collision data at a centre-of-mass energy of 13 TeV recorded with the ATLAS detector at the Large Hadron Collider. No evidence of events beyond the background expectation is found. Upper limits on the non-resonant pp → HH production cross section of 10 pb and on the resonant production cross section as a function of the HH invariant mass are obtained. Resonant production limits are set for scalar and spin-2 graviton hypotheses in the mass range 500 to 3000 GeV.
Not Available
A measurement of the four-lepton invariant mass spectrum is made with the ATLAS detector, using an integrated luminosity of 36.1 fb –1 of proton-proton collisions at √s = 13 TeV delivered by the Large Hadron Collider. The differential cross-section is measured for events containing two same-flavour opposite-sign lepton pairs. It exhibits a rich structure, with different mass regions dominated in the Standard Model by single Z boson production, Higgs boson production, and Z boson pair production, and non-negligible interference effects at high invariant masses. The measurement is compared with state-of-the-art Standard Model calculations, which are found to be consistent with the data. These calculations are used to interpret the data in terms of gg → ZZ → 4ℓ and Z → 4ℓ subprocesses, and to place constraints on a possible contribution from physics beyond the Standard Model.
This paper presents measurements of tt¯ production in association with additional b -jets in pp collisions at the LHC at a centre-of-mass energy of 13 TeV. The data were recorded with the ATLAS detector and correspond to an integrated luminosity of 36.1 fb –1 . Fiducial cross-section measurements are performed in the dilepton and lepton-plus-jets tt¯ decay channels. Results are presented at particle level in the form of inclusive cross-sections of tt¯ final states with three and four b-jets as well as differential cross-sections as a function of global event properties and properties of b-jet pairs. The measured inclusive fiducial cross-sections generally exceed the tt¯bb¯¯ predictions from various next-to-leading-order matrix element calculations matched to a parton shower but are compatible within the total uncertainties. The experimental uncertainties are smaller than the uncertainties in the predictions. Comparisons of state-of-the-art theoretical predictions with the differential measurements are shown and good agreement with data is found for most of them.
The top quark mass is measured using a template method in the $t\bar{t}$→ lepton+jets channel (lepton is e or μ) using ATLAS data recorded in 2012 at the LHC. The data were taken at a proton–proton centre-of-mass energy of √s = 8 TeV and correspond to an integrated luminosity of 20.2 fb –1 . The $t\bar{t}$ → lepton+jets channel is characterized by the presence of a charged lepton, a neutrino and four jets, two of which originate from bottom quarks (b). Exploiting a three-dimensional template technique, the top quark mass is determined together with a global jet energy scale factor and a relative b-to-light-jet energy scale factor. The mass of the top quark is measured to be m top = 172.08 ± 0.39(stat) ± 0.82(syst) GeV. A combination with previous ATLAS m top measurements gives m top = 172.69 ± 0.25(stat) ± 0.41(syst) GeV.
Explore the source record for details and available documents.
This paper presents the electron and photon energy calibration obtained with the ATLAS detector using about 36 fb –1 of LHC proton-proton collision data recorded at √s = 13 TeV in 2015 and 2016. The different calibration steps applied to the data and the optimization of the reconstruction of electron and photon energies are discussed. The absolute energy scale is set using a large sample of Z boson decays into electron-positron pairs. The systematic uncertainty in the energy scale calibration varies between 0.03% to 0.2% in most of the detector acceptance for electrons with transverse momentum close to 45 GeV . For electrons with transverse momentum of 10 GeV the typical uncertainty is 0.3% to 0.8% and it varies between 0.25% and 1% for photons with transverse momentum around 60 GeV . Validations of the energy calibration with J/ψ → e + e – decays and radiative Z boson decays are also presented.
Not Available
Not Available
Not Available
The efficiency of the photon identification criteria in the ATLAS detector is measured using 36.1 fb 1 to 36.7 fb 1 of pp collision data at √s = 13 TeV collected in 2015 and 2016. The efficiencies are measured separately for converted and unconverted isolated photons, in four different pseudorapidity regions, for transverse momenta between 10 GeV and 1.5 TeV. The results from the combination of three data-driven techniques are compared with the predictions from simulation after correcting the variables describing the shape of electromagnetic showers in simulation for the average differences observed relative to data. Data-to-simulation efficiency ratios are determined to account for the small residual efficiency differences. These factors are measured with uncertainties between 0.5% and 5% depending on the photon transverse momentum and pseudorapidity. The impact of the isolation criteria on the photon identification efficiency, and that of additional soft pp interactions, are also discussed. The probability of reconstructing an electron as a photon candidate is measured in data, and compared with the predictions from simulation. In conclusion, the efficiency of the reconstruction of photon conversions is measured using a sample of photon candidates from Z → μμγ events, exploiting the properties of the ratio of the energies deposited in the first and second longitudinal layers of the ATLAS electromagnetic calorimeter.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Not Available
The response of the ATLAS detector to large-radius jets is measured in situ using 36.2 fb -1 of $\sqrt{2}$ =13 TeV proton–proton collisions provided by the LHC and recorded by the ATLAS experiment during 2015 and 2016. The jet energy scale is measured in events where the jet recoils against a reference object, which can be either a calibrated photon, a reconstructed Z boson, or a system of well-measured small-radius jets. The jet energy resolution and a calibration of forward jets are derived using dijet balance measurements. The jet mass response is measured with two methods: using mass peaks formed by W bosons and top quarks with large transverse momenta and by comparing the jet mass measured using the energy deposited in the calorimeter with that using the momenta of charged-particle tracks. The transverse momentum and mass responses in simulations are found to be about 2–3% higher than in data. This difference is adjusted for with a correction factor. The results of the different methods are combined to yield a calibration over a large range of transverse momenta (p T ). The precision of the relative jet energy scale is 1–2% for 200 GeV < pT < 2 TeV , while that of the mass scale is 2–10%. Hence, the ratio of the energy resolutions in data and simulation is measured to a precision of 10–15% over the same p T range.